Wallwasher led SP12 is basically an aluminium based bar LED product. But the LEDs we use on the product are Power LEDs, ie power LEDs. Power LEDs are divided into 3 in the literature as follows.

• Mid-power,
• Semi-power,
• High-power.

In this product, we use Semi-Power LEDs with a maximum power of 1 Watt. Our product is 1.6 cm wide and 30 cm long. There are 12 LEDs on 1 SP12 model. The model therefore generates up to a maximum power of 12 watts. You can shorten the aluminium product by cutting it at 5 cm intervals. Or you can extend it end to end like others.

If you pay attention, the form of the product is different from classic bar LEDs. It is not straight. Because wall painting led We have produced this product, which you will place in a safe, in this form for easy screwing places. The product works with constant current driver. With this product Wallwasher LED lighting can manufacture products.

Wallwasher Ledi: SP12

Volvoshir LED is widely used for exterior wall lighting. Finished Wallwasher LED lighting products paint walls, trees, mosques and other surfaces with coloured or white light. Wallwasher usually consists of high intensity LEDs placed in a linear mould. It creates an aesthetic and impressive atmosphere especially in places such as galleries, hotels and shopping centres.

With SP12 bar LED 30 cm flywheel you can do it. Because the volvosity led length size fits. Thanks to our economic and quality products volvosaurus led prices it would also be highly competitive.

Volvoshire lighting comes in different sizes, colours and powers. Volvoshir price level also depends on this. For example, in the 60 cm volvoshir model, you need to use 2 pieces of this product. This changes both power and price. There are volvoshir light models in many different colours such as amber, white, blue, red, green or RGB. The models spread the light homogeneously and add vitality to the place you install.

How to Calculate Constant Current Driver Power?

For example, you want to make a wallwasher 30cm long and 12W power. Therefore, our product has Semi-Power LEDs with 30×30, 1W and 6V values. Then you need to drive 1 LED 1W/6V = 0.16A, ie approximately 150mA current.

In our design, 2 LEDs are connected in parallel and 6 of them are connected in series. So 36V voltage is required. For a wallwasher with 12W power, 12W / 36V = 0.3A, ie an average current of 300mA is required. The constant current driver you choose must be at least 300mA and the voltage range must cover 36V.

For example, 40W, 500mA and 48-80V are written on a driver. The current meets 300mA, but 36V does not fall within the range of voltage values given. You need to look for another driver. Another driver is 24.5W, 350mA and 25-70V. This driver is suitable for both 36V and 300mA.

Note The word "Volvoşır" is the pronunciation of Wallwasher. However, the reason why it is also referred to as "Volvoşır" in this article is because it is widely used on the internet. The correct spelling is "Wallwasher".